RSS Feed

3 Masted Schooner

19 October, 2012 by EVAN

About this Sailboat:

This vessel is located in the NorthEast United States.

***********PRICE REDUCED AGAIN*************

OWNER WANTS HER SOLD

She was custom designed to fulfill all USCG and SOLAS requirements to carry passengers on oceans. The Certificate of Inspection has currently lapsed. She was recently audioguaged (Planemetrics 37DLPlus) in various areas as a source of additional information of steel condition. Steel was found to have some surface rust in exposed areas where coatings had been poorly or thinly applied- edges etc but overall was well coated and even where thin rusting had taken place, underlying steel was measured “as built”

The engine is a Lugger 6140 Diesel with less than 2300 hours. 6 cylinder, 500HP.

A unique feature of this unique vessel is the ability to cruise in much shallower waters than just about anything else of this size due to the centerboard design. With the centerboard down she draws 19′, but in the up position only 10′. A great advantage when cruising the islands.

There is an extensive inventory that comes with this vessel with a full complement of sails, life jackets, lafe saving equipment, and every amenity you would expect on a relatively new passenger carrying vessel of this size.

Make sure to view the video at www.ruddersandmoorings.com for a virtual tour, and contact us to arrange for a personal inspection.

Equipment on Board:

Electrical System

Two 55 kw Northern Lights Diesel Generators
110, 220, 12-volt
Batteries
House: 110/220 V
Shore :100 A, three phase, 4 wire
2 water makers

Electronics/Navigation Equipment

Ritchie Compass, 8″
Standard VHF
Wind Indicator
Radar – Furuno 1832
Echo sounder
Radar reflector
SSB

Safety/Required Equipment/Surveyor Notes

PFD’s: USCG Type I (33 USC 175)
VDS: Solas standard (33 USC 175)
Bell: Trumpet and Handheld freon
Fire Extinguishers: 7 total
Fixed Fire System: Kidde CO2
Life jackets, safety harnesses
EPIRB,
liferings
flares

Rigging/Sails

13 Sails
8500 square-foot sail area
Standing Rigging: galvanized wire
Turnbuckles: Galvanized
Chainplates: Steel
Running Rigging: Polyester three strand

Deck Equipment

Anchor: 1,000lbs fisherman and 1,00lbs stockless
Chain/Rode:
Bulwarks: Steel
Docklines: Misc 3-strand
Boats: (1) Zodiac-Pro7 w/40hp Evinrude
Deck – Teak over plywood over steel
Cabin Sole – Steel
Hull/Deck Joint: Welded

Mechanical Equipment/Engine Details/Propulsion System

Single Screw 500 hp Diesel, Lugger
Heat exchanged
Reduction Gear: “ZF” 2:1 ratio
3 Blade fixed 64″ Propeller
Cutlass Bearing
4″ Stainless Steel Shaft
Stuffing Box: Traditional w/water injected log

Galley equipment

Garland Heavy Duty 10-Burner Electric Restaurant Range
2 @ 26” x 26” ovens
3-door commercial true refrigerator
microwave
deep freezing system
miscellaneous cooking and bedding

 3 Masted Schooner
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *