RSS Feed

1999 Custom Builder Custom Frers 34ft Composite Cedar/Carbon Fiber/Epoxy

16 October, 2012 by EVAN

About this Sailboat:

Details at: WWW.KABRUM.COM -She was built (over a two year period), w/ follow-up from the designer’s studio, in a climate controlled building (constructed specifically for this project), all longitudinal and transversal beams are carbon-fiber sandwiched for additional strength, all holes drilled in the deck and hull were sealed with epoxy before being used, interior furniture is angled in at the base to provide additional foot room, etc. All first class.

Equipment on Board:

Year: 1999 (in extremely clean condition).
Hull Material: Cold Molded Cedar / Carbon Fiber / Epoxy
Engine: Volvo Penta 2003 (fresh water cooled, diesel, 3 cylinders, 28HP, ~1500 hours)
Sails: North Sails: Full batten Main, G2, G3, G4, Storm Jib, Spinnaker (1999).
Fuel: 27 gals steel
Water: Brand new 66 gals hypalon – via foot pump
Galley: New “Force 10” two burner propane stove

Custom Builder Custom Frers 34ft Composite Cedar/Carbon Fiber/Epoxy
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *