RSS Feed

1989 Catalina Custom Cutter

5 October, 2011 by EVAN

About this Sailboat:

This is not your typical Catalina. The 36’ Catalina was designed as a costal cruiser, but after 5 years of grueling boat projects, this vessel set sail for an around the world voyage starting in California in 1998. First it was sailed to Mexico, through the South Pacific islands including Tonga, and on to New Zealand. From there it visited Fiji and cruised up the east coast of Australia, then headed across the South Indian Ocean to South Africa with short stops in Mauritius and Reunion Islands. The passage continued around the Cape of Good Hope, up the South Atlantic with a brief rest in St. Helena, and on to Trinidad. Then this vessel island hopped through the Caribbean and Bahamas and settled in Florida where it is now for sale again. If you are looking for a world cruiser with all the custom work done for you at a coastal cruiser price, do not hesitate to preview this well built sailing vessel. Article from Good Old Boat “Bluewater Catalina” available upon request. Huge Price Reduction. CALL NOW !

Equipment on Board:

Panasonic Microwave Oven, Deep Double SS sinks, 6 Gallon hot water heater, 2 Burner Mariner SS Stove with oven & broiler-Gimbaled, 2-20 lb Propane tanks-deck mounted, Pressure water w/ actuating tank, Salt water foot pump, Katadyn Power Survivor 40E water maker-12V & 24V 1.5 Gallon an hour w/ sink spigot, Technautics Cold plate
Garmin 276C map GPS, Raytheon Ray 45 VHF, Apelco 265 Fish finder-Depth sounder, Ships Bell, Simrad TP30 Tiller pilot, Kenwood TS 50 SSB radio with antenna coupler & insulated back stay, Mini EPIRB, Tri Color mast top navigation lights, JVC AM/FM/CD Player w/ speakers, Mast top emergency ACR Strobe light, Ritchie 5” compass, Monitor SS self steering windvane.

All 12V lights are red & white, 12V & 110V Electrical Panel, Heart Interface Link 1000, Freedom 10 Inverter, 3-Group 27 House batteries-2009, 1-Group 27 Engine starting battery-2009, 1-Electric/Manual bilge pump w/ float switch and spare, Macerator for holding tank, 2-Arch mounted Siemen 75W solar panels, Xantrex charge load controller for panels, Mast top lightning arrester, Lighthouse 1501 Electrical/Manual horizontal windlass with remote, 1-30amp 50’ 55AMP Motorola alternator.
Stainless Steel Bow & Stern rails, Custom Double Stainless Steel side rails, Custom built 8” high toe rail 1” off deck, 6’ Custom Wooden bow sprit, Double SS bow rollers, 60LB CQR w/300’ chain, Spare Delta plow, Stainless Steel Sampson post 3-Forward Custom deck hatches, 12 Opening screened ports, 2-Amidship dorades, Port, starboard & aft boarding gates, Stainless Steel & Teak boom gallows, Stainless Steel bimini poles, Stainless Steel arch, Edson Pedestal w/separate throttle and shifter, Large cockpit w/ cushions, 2-Cockpit lockers, Tiller steering, Head toilet and SS sink, Storm hatch boards, Heavy duty companionway doors, Keel has added keel bolts for strength, Spare outboard Rudder in locker, Aft coaming anchor roller, Custom life raft mount on SS arch.
Stainless Steel wire standing rigging w/ Staylocks, Cutter rigged with hanked on sails, Double spinnaker poles, Main sail is fully battened with 3 reef points and lazy jacks, 2-Genoas, 2-Staysails, Extra small set of storm sails-Main & Staysail w/ sheets, Small Spinnaker for light air, Running back stays, Mast has 2-Barlow #18 winches and 1-Harken Self tailing #16 winch, Custom boom with hand holds and extra sail support, 2-Lewmar #30 cabin top winches-1 is self tailing, 2-Lewmar #46 Sheet winches on cockpit coaming, 2-Starboard cabin top rope clutches, Mast is keel stepped, Manual boom vang, Custom main sheet Garhaur traveler, Separate storm trisail track, Running rigging in good shape.
3 Bladed fixed prop, Bilge blower, Raycor fuel filter, Fuel shut off valve, Life jackets, Safe w/ key in Starboard locker, Wind scoop, New bottom paint in 2006-Small blisters noticed, 2-30 Gallon Poly water tanks behind aft berth, 1-Gravity feed 10 Gallon water tank

Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
Catalina Custom Cutter
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *