RSS Feed

1983 Tayana 37 MK II Cutter Rig

6 October, 2011 by EVAN

About this Sailboat:

1983 Tayana 37 MK II Cutter Rig. Just completed a 20K paint and varnish job. Over 35K invested into the boat over the past 6 month. New chain plates. New wind generator and charge controller. New Raymarine st-60 instruments and Raymarine A-50D Chartplotter. New cockpit drains, sink drains, shower drains and numerous other critical hoses. Just had $1,500 bottom paint done. The shaft was just checked and balanced and the prop was just checked and straightened. You won’t see a prettier Tayana out there. Engine was just serviced and runs great. Ready to sail or motor away. Some pictures are during the repaint and varnish work process. Ask for more details if needed.

Tom – (# removed) – call or text anytime

Equipment on Board:

Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
Tayana 37 MK II Cutter Rig
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *