RSS Feed

1979 MORGAN 382

17 October, 2012 by EVAN

About this Sailboat:

Harken roller furling with 135% Cruising laminate genoa in good condition, with rope luff. 150%RF genoa,
Inner stay with ABI release lever,2012 Rolly Tasker hank on staysail 160Sf.
2011 New 8oz offshore Main by Rolly Tasker, Cruising Spinnaker with dousing sock,
Whisker pole with all running rigging.
Lewmar 42 self tailing, secondary winches are standard , steps on the mast to the top, back stay is set up for SSB (with insulators), , Heart Freedom 2000W Inverter with a 50 amp charger,125 amp alternator ,Ample Power Smart regulator V3, digital battery monitor, Amp Air 100 wind generator(off the boat),4 6VDC golf cart batteries,12VDC starting battery, new Paneltronics AC and DC circuit breaker panel,
Regulators for both Amp Air and Solar panels.
Maxwell 1200 electric windlass with power up/down foot switches at bow and cockpit. 33# Bruce anchor with 150′ of 5/16 HT chain, 20# Danforth anchor 25′ of 3/8 BBB chain 200′ of nylon rode Salt water anchor wash down ST60 Raymarine sailing, instruments, wind,depth,speed, VHF Standard, Uniden hand held.
Furuno GPS 2007.CPT autopilot (wheel driven),Gusher portable bilge pump, automatic electric pump, Rule 2000 GPM.
Galley,3 burner Regal Mariner propane,stove/oven,with,solenoid shutoff. 2010 ENGEL MT-35 12VDC/115AC refrigerator, Ice box DC refrigeration with Fridge-Boat keel cooler.
50 HP Perkins 4-108 diesel with 1850h,Dual Racor fuel filters and electric emergency fuel pump. All bronze ball valves. All sea-cocks bronze ball valves.
New cutlass bearing,dinghy motor lift crane (currently off the boat)MOB throw-able, ,4regular, 2 throw-able PFDs,2 inflatable PFDs with integral harnesses.
Gas grill on the rail, Stern ladder (removed for Fleming),Fleming Global-501 wind vane. All sea cocks bronze ball valves, rudder modified New Found Metals port lights.
Sunbrella covers, 2011 new main cover. Diesel cabin heater, spares, manuals,
binoculars,

Equipment on Board:

1] Mast was pulled, inspected,
-spreader tips were replaced masthead light lens and bulb replaced, instrument and lights terminations at the mast foot replaced with Ancor ring terminals, terminal block replaced. Thick coat of lanocoat applied to the foot of the mast to assure wary free mast removal in the future, no corrosion.
2] Boom, 2011 Lewmar 07 reefing winch on a Selden winch pad added behind 2 Lewmar rope clutches, to ease reefing. Boom end pulleys replaced.
3] Hull is in v.good condition, no blisters.2010 bottom paint removed and sanded to the barrier coat,3 coats of Interprotect 2000E applied 2 coats of Hydrocoat ablative applied.
4] 2 Wichard 3/8 watertight U-bolts added in the cockpit for safety hook ups.-7/16 U-bolt added behind furler for jack lines, cruising spinnaker, preventer,
5]Maxwell 1200 removed, serviced, 2010 new Maxwell foot switches and all new ring terminals,
6] furler, serviced 2009, 2 deck hatch lenses replaced with 3/8 PC and anti skid added to the top of the lenses, one solar vent added to the bow hatch lens for ventilation.
7] running rigging, 2010 new
8] Engine,2010 lift pump,2009 new fuel distribution panel with emergency electrical fuel pump, 2009 fuel hoses replaced, 2011 new thermostat ,2011 valve clearance checked and corrected, oil changed each season, most of the hoses on the engine replaced, water heater hoses new 2009, new cooper nickel heat exchanger 2012.
9] 2009 Engel MT-35 freezer-refrigerator, 2010 Isotemp Slimline 20 stainless steel water heater , all new hot and cold hoses. 2008 new water panel distribution, all bronze ball valves and fittings. You can pump water from the starboard tank to the port tank. 2008 new VSD water pump,
10] head removed, rebuild, hoses replaced, New vented loop, New Sure flow shower pump.
11] 2011 � battery box rebuild, battery wiring cleaned up, starting battery relocated. Added manual override for battery combiner to prevent starting battery overcharge.
12] Whisker pole serviced, topping lift and guys added to running rigging. 2 piece boom preventer added
13] 2012 � Fleming wind vane installed direct to quadrant, can be used as emergency when steering cables part.
14] 135% RF Pentex genoa � added rope luff, head, tack, clew corners reinforced and sail serviced by Bacon Sails Annapolis.
15] 2012 boom end sheaves replaced
16] 2012 Garhauer back stay tensioner.
17] 2012 rudder packing new
18] 2012 Inner T-e track 8� port-starboard with cars,

MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
MORGAN 382
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *