1977 O’Day

Added 5 October, 2011

About this Sailboat:

Sleeps 4-6
Forward V-Berth with en-suite head, features new fabric cushions and memory foam pad. PT. (port) & stb. (starbord) convertable settees/quarterberths have new vinyl cushions with piping. Galley is at stb. aft, near companionway. The fold down dinette table fastened to the forward bulkhead is a drop leaf design, serving the pt. &/or stb. settees. A bi-fold teak door separates the salon from the head and sink compartment in the V-Berth cabin. There is a cold locker, stainless steel sink. Pak-a-Potti V Head is mid-ship separated from the salon by a bi-fold teak door, Ample counter top & storage areas. Newer carpets, newly painted interior, and reconditioned teak. Fold out ounter extension near SS sink galley. 2 drift anchors, 2007 VHF Radio (Uniden), Water pump for Galley & Head, 2007 Ritchie Compass, new dock lines and 4 new white fenders, USCG safety gear and 6 new life jackets. Hook up for shore power. Original Atomic Four Inboard motor (needswork)
VERY clean inside and out!

Equipment on Board:

O’Day 27 Specifications
L.O.A.: 27′-0″ (8.23M)
L. W. L. 22′-9″ (6.93M)
Beam 9′-0″ (2. 74M)
Draft 4′-0″ (1.22M)
Sail area (100% foretriangle):
340 sq. ft. (31.59 sq. M)
Design Displacement
Inboard, 6,950 lbs. (3159K)
Ballast 2,230 lbs. (1012K)
Ballast with shoe 2,430 lbs.
Mast above water 38′-6″ (11.7M)

O’Day 27 Rig Measurements
E (Mainsail foot) 9.25′ (2.82M)
J (Foretriangle base) 11.67′ (3.56M)
P (Mainsail luff) 29.5′ (8.99M)
I (Foretriangle height) 35.0′ (10.67M)

*Approximates based on the internet

O
O
O
O
O
O
O
O
O
O
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *