RSS Feed

1975 Bristol Bristol 27

6 October, 2011 by EVAN

About this Sailboat:

This Bristol is fresh out of refit.

All Bristol boats are strong, the Bristol 27, being one of the first generation of fiberglass boats, was no exception. They had solid GRP hulls and the deck, cabin, and cockpit was an integral molding and connected to the hull via deck clamp and through bolting. The mast is deck stepped, and is supported by a substantial bulkhead thatÂ’s well tabbed into the hull. Lead was used as ballast and encapsulated in fiberglass. This Bristol 27 is a standard model which had a larger cabin and twin settees.

Equipment on Board:

All deck soft spots have been repaired
Hull to deck joint is fiber glassed over
New Alexseal paint sprayed on hull and cabin exterior
New nonskid
All ports and all hardware re-beded
New Lexan in port lights
New toe rails
Fresh varnish on all bright work
New stainless steel mooring bitt
All new stainless steel cleats
All chain plates replaced 2011
New cap shroud 2011
New head stay 2011
Back has 3 seasons use
All new turnbuckles 2011
Harkin IV unit 0 2011
New 133% genoa 2011
New full batten main one reef point 3 seasons use
New cabin drain seacocks
9.9 Mercury extra long shaft outboard used for three seasons.

More photos here: http://www.flickr.com/photos/b27redsky/

Bristol Bristol 27
Bristol Bristol 27
Bristol Bristol 27
Bristol Bristol 27
Bristol Bristol 27
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *