RSS Feed

1974 Ericson Rigged For Cutter

19 October, 2012 by EVAN

About this Sailboat:

Very well equipped ericson 32

Virtually every system has a back up or a reduntant system!

All focus in upgrades have been to make seaworhty with only little cosmetic attention needed.

My new boat is on the way and I would consider 6k down with a few payments – MAKE OFFER CALL TODAY!!!

Equipment on Board:

135 Jib roller Harken

Dual Reef Point main w/ control lines to aft helm station wheel

7 winches 4 are 2 speed and tailing near new spinnaker with three poles one is for whisker / jib

Ericson Rigged For Cutter
Ericson Rigged For Cutter
I do my best to post the most accurate information I can find, but please be aware that information here may be incorrect. If you have any comments about this boat, corrections to the specifications listed, or can provide additional information or photos, please use the comment form below and share what you can. I will update information as it becomes available.

No Comments »

No comments yet.

Leave a Reply

Your email address will not be published. Required fields are marked *